diy frag plugs

[CarloV]

tintry ko gumawa ng frag plugs.

bumili ako ng white cement.

gumawa ako ng mga butas sa sand para magka-mold.

tapos nung hahaluin ko na yung cement, sabi add water until desired consistency is reached.

ano dapat yung ratio ng water to cement pag-mix?

[Sea Turtle]

as far as i know it's 4 (cement) : 1 (water) or 2:1. but you can add more water to "soften" the mixture more.

[CarloV]

Thanks sir! Tinry ko na, sa unang try ko, kulang ata buhangin, nagcrack agad hehe

[Sea Turtle]

cracking usually means the mixture is short in water. you can avoid this by spraying enough water (just enough to get the plugs wet) on the frag plugs while it's curing/drying in 15-20 minutes interval for a period of let's say 3 hrs or so.

[CarloV]

ahhh... ganun pala yun haha.

sige, try ko sa susunod kong batch.

thank you!

[marvin031386]

sir ano pong cement ang ginamit nyo...tia

[CarloV]

yung white portland cement.

basta sabi ko lang sa hardware, "may semento ba na white?"

sabi meron. yun na hehe. P20/kilo.