(will be updated periodically)
![Image](http://www.algaescrubber.net/Post1.jpg)
A little over a year ago in April 2011, another idea came along: Instead of letting the water flow down a screen like a waterfall, how about you let the water flow up the screen using air bubbles? Why? Because as good as waterfall algae scrubbers are, they still need a place for the water to drain "down" to. This means that you need to have a sump below the aquarium, or you need to have the scrubber up above the aquarium. This is not easy, and is very difficult for a nano aquarium which usually has no sump below it, and no room above it. Also, the waterfall version requires it to be out of the water (in the air), which takes up extra space. The new "upflow" version, however, can be placed inside the aquarium, so that it takes up no extra space at all, and it needs no external plumbing or water pumps at all. Only air bubbles.
The Upflow Algae Scrubber (UAS) provides the best growing conditions for algae in your tank: Air bubbles provide rapid turbulent flow; Strong lighting provides the light; and the nutrients that are already in your water provide the nitrate and phosphate. All that's needed is a place for the algae to attach to, and that is provided by the roughed-up plastic screen. Thus the algae start growing on the screen because the flow and lighting are stronger there than they are in the rest of your aquarium; nitrate and phosphate are consumed in the process. This causes algae to start disappearing from your aquarium and start re-appearing on the scrubber screen, so that you can throw the algae away every week or two.
The most basic way to set up an Upflow Algae Scrubber, especially in small aquariums, is just to put some air bubbles beneath a vertical screen. If inside an aquarium, you just put a light on the outside of the glass, so that it shines inside to the screen. And if you want better performance (which means better filtering), just add a reflector to give the screen some light on both sides. The screen is best made with 7-mesh cross stitch plastic canvas that you get at sewing or craft stores, or online. Also, don't forget to rough up the screen with a sharp object like a hole saw; the screen should be so rough that the screen holes are almost filled in with all the little pieces of plastic that you roughed up.
Watch out for your fish or snails eating your filter! There's nothing tastier than live green algae, so your fish or snails may keep your screen from getting very thick. The simple solution is to just put some mesh or netting around it.
The following updated picture has size guidelines:
(will be updated periodically)
![Image](http://algaescrubber.net/Sizing.jpg)
And the following updated picture has examples:
(will be updated periodically)
![Image](http://algaescrubber.net/Examples.jpg)
So build a UAS and post your pictures!
.
.
.