DIY frag Tong

[Jake]

Materials needed


1- baloon holder
2- drill two holes as shown
3-any piece of hard plastic, drill four holes as shown
4-assembled head tong without fishing line. As you can see from the finished product that gingy is holding.


Will show you how to assemble the holding nylon tie.


Just follow the picture.


Do the same on the other side.


This is how to tie the fishing line control.


Finished assembled tong.
Thank you for viewing.

[jazz0821]

Wow, thank you sir jake for sharing your diy tong

[tugasi]

eto tunay kong idol si sir JAKE

[Sea Turtle]

galing! ipa-patent nyo na yan uncle at baka i-mass produce ni roland yan!


*biro lang roland

[AdamWarlock]

thanks for sharing unlce jake! nice toys!

[jemzac]

Naka patent yung "uncle jake" 
Ang galing, pati demo toys kaaliw, very creative ang AKING uncle Jake 

[Jake]

thanks ms jem, AdamWarlock, Sea Turtle, tugasi, jazz0821.

[blackwidow]

Nice one bro. Happy nko nasa akin yung first model nya. Hehe.

[Jake]

[rolandgelo]

[argon1199]

pardon my ignorance po. ano po gamit ng tong compared to just sticking in your hand?

[sid]

There are a couple of reasons why we dont want to always stick our hands in our tank... and most of it is health related.

Nice DIY project by the way brudah!

[Jit]

[Jake]

@ argon1199 - the tong was made to be able to make small ajustment without putting your hand in the tank. Then other uses were found just as sid and Jit said. Lastly we wanted to make a tong that is so cheap in materials, that anyone can make.

@ sid and Jit - Thanks bros.

[argon1199]

I see. Thank you po sa clarifications. I learned something new today