greetings RP! i'll start a new DIY thread again and this time it's about an ATS unit. the unit will be using a pair of 24" x 6" screen, probably a 2000lph powerhead (or more), 4 12" T5 NO's warm white (i should have bought the 24" t5's should i've known that i will modify my original design...
the original design is an in-sump unit. but later on i had thought that i would just instead using it as an overhead unit. here's a cross section of the original design:
and here's the modified design...
...this unit will be used in an experiment to test the ats's efficiency. thoughts, concerns &/or suggestions are very much welcome.